Abstract The potential of near-infrared spectroscopy (NIRS) to predict the physicochemical characteristics of the porcine longissimus dorsi (LD) muscle was evaluated in comparison to the standard methods of pH and color for meat quality analysis compared to the pH results with Colorimeter and pH meter. Spectral information from each sample (n = 77) was obtained as the average of 32 successive scans acquired over a spectral range from 400 - 2498 nm with a 2 - nm gap for calibration and validation models. Partial least squares (PLS) regression was used for each individual model. An R2 and a residual predictive deviation (RPD) of 0.67/1.7, 0.86/2, and 0.76/1.9 were estimated for color parameters L*, a *, and b*, respectively. Final pH had an R2 of 0.67 and a RPD of 1.6. NIRS showed great potential to predict color parameter a * of porcine LD muscle. Further studies with larger samples should help improve model quality.

The objective of this study was to evaluate the consequences of low or high stress during pre-slaughter handling of pigs on their carcass and meat quality. Forty-four animals of a commercial lineage, with an average weight of 107.23±5.23 kg, were used. At lairage the animals were randomly divided into two groups, the least and the most stressed. At slaughter, during bleeding, blood samples were collected for later cortisol and lactate tests. Forty-five minutes after slaughter the initial pH of th carcasses was measured and samples of the semitendinosus muscle were collected for R-value calculation. After 24 hours of cooling, the final pH was measured, damage scores were assessed and samples of the longissimus dorsi muscle were collected to evaluate drip loss, liquid loss from defrosting and cooking, shear force, lipid oxidation, and color. The results were evaluated by analysis of variance and the means were compared by Tukey´s test. It was found that cortisol, lactate and R-value were lower and initial pH was higher for the least stressed animals, whereas the other parameters were not significantly affected. Thus, low stress in the pre-slaughter handling of pigs is effective in reducing stress and carcass damage, but has no effect on meat quality.

The objective was to evaluate the dietary supplementation of different sources of chromium (inorganic: chromium sulfate and chelated: chromium-methionine) during the finishing period of pigs to obtain improvements in the animal performance, and carcass and meat quality. The statistical design was randomized blocks, where 44 barrows, with an initial weight 60.49±5.12 kg, were divided into four blocks (heavier, heavy, light and lighter) according to initial weight. The experimental diets were isoenergetic and isonutrient, except for the chromium level. The treatments were divided as follows: control (without chromium), control + 200 ppb of inorganic chromium (chromium sulfate), and control + 200 ppb of chelated chromium (chromium-methionine). In the performance measures, the stall was considered the experimental unit and in the blood parameters, carcass and meat evaluations each animal constituted the experimental unit. Animals were slaughtered when they reached the final average weight of 107.23±5.23 kg. Blood samples were collected and tested for blood parameters (cholesterol, triglycerides and glucose) as well as carcass quality (hot and cold weights, yield, loin-eye area, muscle depth and backfat thickness) and meat quality (initial and final pH, drip loss, color, chemical composition and lipid oxidation) parameters. Chromium-methionine supplementation provides a greater daily weight gain only compared with the animals that are not supplemented with chromium, because feed conversion is better as compared with the other treatments. After 24 hours of storage, the meat from pigs supplemented either with chromium-methionine or with chromium sulfate presents lower lipid oxidation than that from non-supplemented animals. However, after three days of storage, only chromim-methionine is effective in reducing lipid oxidation.